Creative MUVO 20 MF8185 - Portable Speaker Quick Start Guide

Creative MUVO 20 MF8185 - Portable Speaker Quick Start Guide

Advertisement

Creative MUVO 20 MF8185 - Portable Speaker Quick Start Guide

Overview

Front

Overview - Front

  1. Multifunction Button
    For Bluetooth ® Pairing / Connecting / Answering calls
  2. Status Indication LED
  3. Battery Indication LED
  4. Volume Controls
  5. Microphone

Back

Overview - Back

  1. NFC Receptor
  2. Bass Port
  3. Power Button
  4. Aux-In
  5. USB DC Out Port
  6. USB port
    (For Charging only)

warning Note: The AUX-IN has a fixed volume.
To adjust the volume on the AUX-IN, adjust the volume control from the source device.

Pair it

NFC Pairing

NFC Pairing
Tap your NFC-enabled smart device on the top of the MUVO 20 and they're paired.
Did you know?
You can use NFC to power ON the speaker. Simply just tap and go!

Manual Pairing

Manual Pairing

  1. Power ON the speaker by pressing the Power Button at the rear of the speaker.
  2. Press and hold the Multifunction button until the Status Indication LED starts blinking white rapidly.
  3. Select the MUVO 20 from the list of discovered Bluetooth devices, and they're paired!
LED Indication Status
Solid Green LED Powered ON but not connect to any Bluetooth devices
Blinking White LED Pairing Mode, waiting for device to connect
Solid White LED Connected to a Bluetooth device

Use it

Play Music

Play Music
Tip
To allow a second NFC or Bluetooth device to connect to your speaker, simply turn off the Bluetooth on your phone or tap again at the NFC receptor to disconnect.

Take Calls / Reject Calls

Take Calls / Reject Calls
Press the Multifunction button to pick up an incoming call
OR
Press and hold the Multifunction button for 2 seconds and release to reject an incoming call

Useful information

Charge your mobile device on the go!

Simply plug your USB cable to the rear of the speaker USB DC Out and the other end to your mobile device to charge.
Charge your mobile device

Battery Indication

Battery Indication

LED Indication Status
Solid Red LED Charging
Red LED disappears with USB power attached. Fully charged

Did you know?
You can check your battery's status by simply pressing the Multifunction button twice rapidly.

Charge it up

For optimum performance, please charge the speaker for approximately 8 hours before use.

*Battery performance may degrade over time depending on charging cycles.

Battery saving: The speaker automatically powers down when there is no Bluetooth connection or no audio input for more than 15 minutes.

Charge it up
(Not included. USB adapter with DC 5V and up to 1A output rating can be used)

Tip
For optimized charging performance, please ensure your speaker is powered off and your mobile device is disconnected from charging via speaker.

© 2014 Creative Technology Ltd. All rights reserved. Creative, the Creative logo and MUVO are trademarks or registered trademarks of Creative Technology Ltd in the United States and/or other countries. The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Creative Technology Ltd is under license. All other trademarks are the property of their respective owners and are hereby recognized as such. All specifications are subject to change without notice. Actual contents may differ slightly from those pictured. Use of this product is subject to a limited warranty.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Creative MUVO 20 MF8185 - Portable Speaker Quick Start Guide

Advertisement

Need Assistance?

Do you have a question about the MUVO 20 that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents