Table of Contents
Advertisement
5.5
Attach the Oral Tube bracket to the
Oral Tube
1.
Place the Oral Tube bracket as low down the oral
tube as possible
2.
If there are whistles and lights fastened to the Oral
Tube then place them above the ResQLink AIS
bracket or attach them elsewhere to the life jacket,
3.
Rest the ResQLink AIS on the Oral Tube and pass
the free end of the tape around the back of the life
jacket bladder taking care not to twist the tape.
4.
Pass the tape over the oral tube
5.
Feed the tape into the rearmost slot in the side
of the ResQLink AIS so that it emerges from the
front slot
6.
Loop the tape around and into the foremost slot
on the side of the ResQLink AIS so that it emerges
alongside the inserted tape
7.
Pull approximately 25mm (1") of tape through the slots in
the ResQLink AIS
8.
Clip the ResQLink AIS into the Oral Tube bracket
taking care not to trap any loose tape
9.
Pull the tape tight with the free end of the tape
so that the bladder is free to inflate and remains
folded in accordance with the life jacket manufac-
turer's instructions. Do not over tighten the tape
10. Test for tightness by ensuring you can freely insert
a finger in between the tape and the bladder.
20
USER MANUAL
912S-03765-01.00
12/11/2022
Advertisement
Table of Contents
