Table of Contents
Advertisement
2.5
AIS message reception
The method in which an AIS message is displayed will depend on the reception equipment being
used. AIS enabled plotters will display a target either as a ship or SART target with the ResQLink
AIS's preprogrammed MMSI number that identifies it as an AIS Location device.
2.6
Rewinding the antenna
If the ResQLink AIS is activated during this process, turn it
!
off by pressing the TEST/OFF Key until the red LED flashes
twice.
Rotating the antenna rewind tool in the clockwise direction
!
will damage the antenna
•
Use the Antenna Rewind tool supplied in the box.
•
Place the moulded cap of the antenna into the space
•
Pass the tool through the round hole in the top of the
ResQLink AIS and place over the antenna just behind the cap.
•
Rotate the tool anti-clockwise until the antenna is fully wound.
•
Hold the tool keeping the antenna coiled
Do not remove the tool until the slider is in place
•
Push the Activation Slider into place
•
Release and remove the rewind tool to allow the antenna to
rest behind the Activation Slider
NOTE:
Refer to section 5 when installing in a life jacket
regarding attachment of the Activation Tape to the Slider.
2.7
False Alerts
If the ResQLink AIS is accidentally activated, it should be immediately turned off. If active for more
than 30 seconds the nearest Coast Guard Centre or Rescue Coordination Centre should be contacted
to explain that the ResQLink AIS has been activated in error and there is no follow up rescue actions
required. See inside the back cover for information required in the event of a false activation. If appro-
priate make a call on the VHF radio to announce the same information.
The information that should be reported includes-
•
the ResQLink AIS 15-Hex ID;
•
date, time, duration and cause of activation; and
•
location at time of deactivation.
Note:
In the event of a false activation in the USA call toll free:
3.
TESTING
Routine testing of your ResQLink AIS once a month is recommended to ensure it is in good working
order. Follow the guidance notes below on the frequency that tests should be carried out. Remember
that each test will reduce the battery capacity slightly and reduce the operation time of your ResQLink
AIS during an emergency.
Should a test fail it is advised to repeat the test to confirm failure before returning the ResQLink AIS
to ACR Electronics or an approved service agent.
When carrying out any test the antenna should be extended.
!
If the ResQLink AIS activates during the removal of the antenna retainer, press and hold
the Test/Off button until the LED flashes red twice to deactivate.
See section 2.6 above for antenna rewind instructions.
12
USER MANUAL
912S-03765-01.00
1-800-851-3051
12/11/2022
Advertisement
Table of Contents
