Install Ink Cartridges - Epson WorkForce 600 Series Start Here Manual

4

Install ink cartridges

Note:
Don't load paper before installing the ink cartridges.
1
Lift up the scanner.
2
Open the cartridge cover.
3
Shake the ink cartridges
gently 4 or 5 times, then
unpack them.
4
Remove only the yellow tape from each cartridge.
C aution:
Don't remove any other seals from the cartridges.
5
Insert the cartridges in the
holder for each color.
6
Press the cartridges down until they click.
7
Close the ink cartridge cover and press it
down until it clicks.
8
Close the scanner.
9
Press the OK button to charge ink. Charging takes about 2 minutes.
N ote:
Your WorkForce 600 Series ships with full cartridges and part of the
ink from the first cartridges is used for priming the WorkForce 600 Series.
Caution:
Don't turn off the WorkForce 600 Series while the ink system is
initializing or you'll waste ink.