Any Problems - Epson Stylus Photo RX600 Start Here Manual

Selecting the RX600 in Mac OS X
1
Open the OS X Applications folder, then open the Utilities folder and
start Print Center or the Printer Setup Utility.
Note: If you see a screen asking if you'd like to add a printer, click Add.
2
On the Printer List screen, click the Add button.
3
On the next screen, select EPSON
USB from the pull-down menu.
4
Click Stylus Photo RX600.
Note: If the RX600 doesn't
appear, make sure it is turned
on and securely connected to
your Macintosh.
5
Open the Page Setup menu at the
bottom of the screen and select All.
6
Click the Add button. The Printer List
now includes two entries for your printer.
7
Close Print Center or the Printer
Setup Utility.
8
If you print or scan with Mac OS 9 applications, restart your Macintosh
in OS 9 and repeat all the steps under "Macintosh" to install the
necessary software for them. Then remove the CD-ROM.
Selecting the RX600 in Mac OS 9
1
Open the Chooser from the Apple menu.
2
Select the SP RX600 Series icon, then
click your USB port icon and turn on
background printing.
3
Close the Chooser.
Now you're ready to copy, scan, and print! See "Any Questions?" to the right
to find out how.

Any Problems?

If the red ! error light is on, check for messages on the RX600 LCD screen.
They give you guidance for solving problems.
If your problem is listed below, try the suggestions here. For more solutions,
see your User's Guide.
A New Hardware Wizard
screen appears on your
computer.
You see an error message
when printing or
scanning.
The RX600 doesn't work.
Click Cancel and follow the steps in section 8.
Disconnect the RX600 cable before installing
software.
Make sure your RX600 is connected to your
computer, plugged into a power source, and
turned on.
Try turning the RX600 off and then back on to
clear the error.
Unlock the scanner by sliding the transportation
lock. See section 2.
Unlock the printer by removing and storing the
orange plastic print head lock. See section 4.
Make sure all the ink cartridges are pushed down
all the way. See section 6.
Try connecting the USB cable to a different USB
port on your computer. See section 8.
Turn the RX600 off and then on again.
If it still doesn't work, try reinstalling your
software. See section 8.