Advertisement
TP-Link Archer AX53 and AX55
Troubleshoot using lights
On our router there are six lights. If you're experiencing problems the
lights are a good place to start your troubleshooting.
When the router has power and access to internet the lights might look
like the image above. If anthing is connected to the ethernet-ports,
the ETHERNET-light will be on. Same with the USB-light.
POWER
blinks slowly when the
router is starting up or being up-
dated. Do not turn off your router.
POWER
blinking quickly means a
WPS-connection is in progress.
When
POWER
powered off.
2.4 GHz
is on when the 2.4 GHz
wireless band is enabled.
5 GHz
is on when the 5 GHz
wireless band is enabled.
INTERNET
is blue when
internet-service is available.
Easy troubleshooting
1. Restart your router by turning it off using the power-button, waiting
5 sec and turning it on again.
2. Troubleshoot using the routers lights using the guide seen above
(check your fiberconverter or cablemodem too).
3. Problems with wifi: try connecting an ethernet cable from the router
to your computer. If this fixes the problem something is wrong with the
wireless network. A common reason for this is that wifi has
been turned off using the wifi-button. Or that something in the routers
surroundings or a close neighbour's wifi is interfering with the signal.
4. If the problems remain, try bypassing the router (if you have a
cablemodem your need to release your IP-address, contact us and
we'll help you). Use the ethernet cable between your router and
fiberconverter/cablemodem. Instead of having your router connected,
connect a computer instead. Restart the computer. If internet works
now the problem is in your router.
Troubleshooting
is off the router is
WPS/Wi-Fi
Reset
Power
Reset
Power On/Off
INTERNET
is orange when the
router's internet-port is connected
but no internet service is available.
ETHERNET
is on when at least
one device that is turned on is
connected to the LAN-ports.
USB
is blinking when USB-device
is being identified.
USB
is on when the
connected USB-device is ready to
use.
WAN
LAN1
LAN2
LAN3
LAN4
Advertisement
