Attaching Or Removing Battery Pack - Panasonic EY7552 Operating Instructions Manual

WARNING
• Do not use other than the Panasonic
battery packs that are designed for use
with this rechargeable tool.
• Panasonic is not responsible for any
damage or accident caused by the use
of recycled or counterfeit battery pack.
• Do not dispose of the battery pack in a
fire, or expose it to excessive heat.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack in
the same container as nails or similar
metal objects.
• Do not charge the battery pack in a
high-temperature location, such as next
to a fire or in direct sunlight. Otherwise,
the battery may overheat, catch fire, or
explode.
• After removing the battery pack from
the tool or the charger, always reattach
the pack cover. Otherwise, the battery
contacts could be shorted, leading to a
risk of fire.
• When the Battery Pack Has
Deteriorated, Replace It with a New
One. Continued use of a damaged
battery pack may result in heat
generation, ignition or battery rupture.
• To prevent leakage, overheating,
smoke generation, fire, and rupturing
from occurring, follow these instructions
when handling our rechargeable power
tools (tool main body/battery pack/
charger).
- Do not allow material cuttings or dust
to fall onto the battery pack.
- Before storing, remove any material
cuttings and dust from the battery pack,
fit red plastic "terminal cover", then
place separately from metal objects
(screws, nails, etc.) in tool case.
Damage caused by loose objects in the
case will not be covered by warranty.
• Do not handle the rechargeable power
tools in the following way.
(There is a hazard of smoke
generation, fire, and rupturing)
- Use or leave in places exposed to
rain or moisture
- Use submerging in water
II. ASSEMBLY
Attaching or Removing Sock et
1. Attaching Socket
1) Remove the rubber ring and pin.
[Fig.1]
2) Attach the socket putting each holes.
[Fig.2]
3) Attach the rubber ring and pin in
reverse order of 1). [Fig.3]
NOTE:
Attach socket firmly by using pin and
rubber ring.
Retainer ring is only for temporary
fixing.
2. Removing Socket
1) Remove the rubber ring and pin.
[Fig.4]
Attaching or Removing Battery
Pack
1. To attach the battery pack: [Fig.5
Align the highlighted marker points and
attach battery pack.
Slide the battery pack until it locks into
position.
2. To remove the battery pack: [Fig.5
Push the button and slide the battery
pack forward.
- 9 -
EN
]
]