Installation - HP 350 Installation Manual

Installation

Complete the following steps to install your access point using the HP 350 AP Wall Mount
Kit.
To install the HP 350 Mount Kit on a flat surface, see
l
flat surface on page
To install the HP 350 Mount Kit onto a wall box, see
l
a wall box on page
Installing the mount housing on a flat surface
1. Hold the paper template included with this mount kit against the surface where you
want to install the mounting bracket, and mark the location of the screw holes.
2. Drill holes at the points indicated.
3. Install wall anchors if necessary. Wall anchors are not included in this kit.
4. Align the screw holes in the mounting bracket with the previously installed wall anchors
or marked drill holes and secure into place. See Figure 1.
3
3.
6.
Installing the mount housing on a
Installing the mount housing onto
HP 350 AP Wall Mount Kit | Installation Guide