Power Cords - Compaq Armada E500 Series Reference Manual

WARNING:
!
powered real-time clock circuit. There is a risk of explosion and
injury if the battery is incorrectly replaced or improperly handled. Do
not attempt to recharge, disassemble, immerse in water, or dispose
of it in fire. Replacement should be done by a Compaq authorized
service provider using the Compaq spare part for this computer.

Power Cords

If you were not provided with a power cord for your computer or
for an AC power accessory intended for use with your computer,
you should purchase a power cord that is approved for use in your
country.
The power cord must be rated for the product and for the voltage
and current marked on the product's electrical ratings label. The
voltage and current rating of the cord should be greater than the
voltage and current rating marked on the product. In addition, the
diameter of the wire must be a minimum of 0.75 mm²/18AWG,
and the length of the cord must be between 5 feet (1.5 m) and
6½ feet (2 m). If you have questions about the type of power cord
to use, contact your Compaq authorized service provider.
A power cord should be routed so that it is not likely to be walked
on or pinched by items placed upon it or against it. Particular
attention should be paid to the plug, electrical outlet, and the
point where the cord exits from the product.
This computer contains an internal lithium battery–
In North America, dispose of nickel metal hydride or
lithium ion batteries by taking advantage of the
Compaq battery recycling program. You will be
provided with a postage-paid battery pack mailer
preaddressed to a reclamation facility where the metals
are recycled. Call the telephone number listed for your
location in Appendix A for more information.
In Europe, do not dispose of batteries with general
household waste. Dispose of or recycle them by using
the public collection system or returning them to
Compaq, your authorized Compaq partners, or their
agents.
Regulatory Notices B-5