Table of Contents
Advertisement
A.1 Overview
Some Supermicro switches can be equipped with an optional rail kit to make it easy to install
them in a rack. This manual provides instructions for installing the mounting rails onto a rack
and for installing the switch into the mounting rails. Following these steps in the order given
should enable you to have the system operational within a minimum amount of time.
A.2 Unpacking the System
You should inspect the box the switch was shipped in and note if it was damaged in any
way. If the switch itself shows damage you should file a damage claim with the carrier who
delivered it.
Decide on a suitable location for the rack unit that will hold your switch. It should be situated
in a clean, dust-free area that is well ventilated. Avoid areas where heat, electrical noise and
electromagnetic fields are generated. You will also need it placed near a grounded power
outlet. Be sure to read the Rack, General and Lithium Battery Precautions in the next section.
A.3 Preparing for Setup
The optional rail kit ships in a separate box and that box should include two sets of rail
assemblies, two rail mounting brackets and the mounting screws needed to install the system
into the rack. Read this section in its entirety before you begin the installation procedure
outlined in the sections that follow.
Choosing a Setup Location
•
Leave enough clearance in front of the rack to enable you to open the front door completely
(approximately 25 inches).
•
Leave approximately 30 inches of clearance in the back of the rack to allow for sufficient
airflow and ease in servicing.
•
This product is for installation only in a Restricted Access Location (dedicated equipment
rooms, service closets and similar environments).
Appendix A
Rack Installation
39
Appendix A: Rack Installation
Advertisement
Table of Contents
