Important; Led Charging Indications; Charging; Recharging - Philips Norelco Advatage 6756X User Manual

4. E N G L I S H

IMPORTANT

B Only use the power plug and the charging stand provided
to charge the razor.
B The power plug transforms 100-240 AC volts to
12 volts DC.
B An adaptor plug may be necessary for cord usage in
some foreign countries.Your new razor will automaticall y
convert internally to work on 100V to 240V AC/DC
systems.

LED CHARGING INDICATIONS

B As soon as you start charging the razor, the green
charging indicator light will go on.
B When the batteries have been fully charged,the green
charging indicator light will start blinking.
B The red recharging indicator light will blink when the
batteries are almost empty.
B The red recharging indicator light will blink a few times
after the shaver has been switched off.

CHARGING

B Charging or recharging at temperatures below 40ºF or
higher than 95ºF adversely affects lifetime of batteries.
B Battery Performance is best if you recharge only when
batteries are (almost) completely empty.
B Do not charge razor in pouch.
1 Connect the small plug into the charging stand and put
the power plug into any 100V to 240V AC/DC outlet.
Use only the cord and stand provided.
2 Place the razor in the charging stand.The green
charging indicator light will go on.
3 First time charging and recharging after non-use for
1 month or more requires a full 4 hours.

RECHARGING

B First time charging requires 4 hours.
B After initial charge, recharging normally takes 1 hour.
B When batteries have been fully charged,green indicator
light will start to blink. A fully charged razor has
cordless shaving time of up to approx.40 minutes.
Return razor to charging stand after shaving.
B Red recharging indicator light will blink when batteries
are almost empty.

INSERTING THE FIRST CARTRIDGE

1 Take one lotion or gel cartridge from the box.Take the
connector from the same box supplied and remove it
from the little bag.Push it into the plastic cap of
cartridge until it locks into position with a click.
2 Push the release slide on the back of razor downwards
and open the cover of the cartridge compartment.
3 Slide the cartridge with the connector in place into the
razor. It only fits properly if the white side of the
connector is pointing upwards.Close the cover.
E N G L I S H 5.