Assembly - Husqvarna 525iLST Operator's Manual

SAVE THESE
INSTRUCTIONS
To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows. Do not place loop handle or suspension ring
on label.
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING:
remove the battery. Use protective gloves.
WARNING:
attachment guard that is recommended for
the cutting attachment. See
page 20 .
WARNING:
cutting attachment can result in injury or
death.
12

Assembly

Stop the product and
Always use the cutting
Accessories on
An incorrectly attached
To attach the cutting attachment guard
1. Attach the cutting attachment guard (A) to the hook
on the plate holder (B).
B
A
2. Install the cutting attachment guard on the shaft and
tighten it with the bolt (C).
To remove the cutting attachment
guard
• Loosen the bolt (C) and remove the cutting
attachment guard (A) from the shaft.
A
C
C
1920 - 001 - 28.11.2022