Sonos Era 100 Manual page 17

Set it up
1 Take everything out of the box and
place the base in the packaging slot
to stabilize it for the next few steps.
Thread the end of the Sonos Era 100
power cord that attaches to the
speaker through the opening in the
stand base and into the pole channel.
Caution: This stand is intended only
for use with Sonos Era 100.
2 Position the washer with the
alignment pins facing in. Then align
the stand pole with the base, using
the alignment pins to guide you.
3 Fasten the base (with the washer) to
the stand pole using 1 long screw
(included) and a Phillips-head
screwdriver. Make sure the cord can
still slide freely.