Before You Do Anything Please Read This; Installation Requirements - Oki B8300 User Manual

BEFORE YOU DO ANYTHING PLEASE READ THIS

Installation requirements

Due to the complexity and requirement for parts alignment, this machine must be installed by a suitably
qualified Engineer unless the configuration being is installed is the printer unit and the 500-sheet multi-
purpose tray (B83MP) only.
Improper installation may damage this product. Please note the following during initial installation and
whenever the machine is moved.
1. The machine should be installed near an
accessible power outlet for easy connection.
2. Be sure to connect the power cord only to a
power outlet that meets the specified
voltage and current requirements. Also
make certain the outlet is properly
grounded.
3. Do not install your machine in areas that are:
damp, humid, or dusty
●
exposed to direct sunlight
●
poorly ventilated
●
subject to extreme temperature
●
or humidity changes, e.g., near an air
conditioner or heater.
4. Be sure to allow the required space around
the machine for servicing and proper
ventilation.
A small amount of ozone is produced within the printer during operation. The emission level is
insufficient to cause any health hazard.
The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m
eight-hour time-weighted average concentration. However, since the small amount that is emitted may
have an objectionable odour, it is advisable to place the printer in a ventilated area.
Before you do anything please read this — 6
30cm
80cm
60cm
60cm
3
) calculated as an