Hyundai HSL422103 User Manual

Quality lighting from green energy
HSL422103
INTRODUCTION
You are now the proud owner of the Hyundai Solar Durable lantern
light! For best results study the manual carefully before using the
Hyundai Solar Durable lantern light. Please keep this manual handy for
ready reference. During the day, the solar panel converts solar power
into energy and stores it in the rechargeable battery. At night, the light
turns on automatically and uses energy stored in the battery. The
duration of the illumination will depend on your geographical location,
weather conditions and seasonal light availability.
BEFORE FIRST USE
Solar light has a solar panel that converts sunlight into electricity.
During the day, the electricity converted by the solar panel is stored
in the rechargeable battery. At night, the solar light is powered by
the battery using the electricity stored during the day. The operating
time depends on geographical location, daily weather conditions and
season.
CHOOSE THE RIGHT LOCATION
Select a location with full, direct sunlight. Do not install in shady areas
as these areas will not allow the battery to be fully charged and will
reduce nighttime working hours. Be sure that the selected location is
not close to other nighttime light sources such as street lights or porch
lights. These light sources may keep the solar lights from turning on
automatically.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
No tools required for assembly and installation.
1. Turning on the light
• Remove the plastic film before using.
• Lift up the lens assembly (D) from the lantern frame (C), and turn
the lens counterclockwise and up from the battery the battery box
upper cover and bulb (E) to expose the pull tab.
• Pull out the pull tab to allow the battery to start operating.
Reassemble. The solar light is now activated.
Assembly and installation
• Assemble the wall mount (A) and hangar (B) with nut ansd bolt
PM4*12. (I).
• Use the wall mount (A) as a template to mark and drill holes at the
mounting location. Insert plastic expansion anchors (I) into drilled
holes, and screw in wall mount / hanger (A&B) with three PA4*40
screws to affixed area.
• Hang the lantern assembly (C) on the hanger. You solar light is now
installed.
MAINENANCE
Replacing the battery
• To access the battery follow directions in Step 1.
• Turn the bulb counterclockwise and pull out. Unscrew three PA2.6*8
screws and one KA2.6*8 screw to release the battery box lower
cover (F) from the battery compartment (H) to access the battery
area.
• Remove the Ni-Mh rechargeable battery (G) carefully and replace
with a new one.
Reassemble the solar light.
KEEP THIS INSTRUCTION MANUAL FOR REFERENCE AS
IT CONTAINS IMPORTANT INFORMATION.
NL / EN - support@alleenonline.nl
BE / FR - support@alleenonline.be
Solar Modern pathway bollard light
CHARGING THE BATTERY
For optimum performance, it is best to install the solar lights in full
sunlight and charge for 10-12 hours. Allow the light to run at least
8-12 entire charging and discharging cycles to reach batteries
maximum capacity.
TROUBLESHOOTING
If your solar garden light does not turn on at night, it may be caused
by the following:
• Pull tab has not been taken out: Take pull tab out and allow the light
to charge for at least 8 hours in direct sunlight.
• Battery is not fully charged: Make sure the light is placed in an
area where the solar panel gets the maximum amount of full, direct
sunlight everyday. If the solar panel does not receive enough
sunlight during the day (e.g. due to cloudy or overcast weather
conditions), it will be re-charged on the next sunny day and resume
operation.
• Other light sources: Your solar garden light is located too close to
street lights, porch lights or other lights. These light sources may
turn the solar light off automatically. Relocate the solar light or
eliminate those other light sources.
• Ficture installed in a shady area, for example in the shadow of a tree
or a house. Move the fixture to an area that get full direct sunlight.
• The Nickel Metal Hydride (Ni-Mh) Rechargeable battery may be
faulty: Replace battery.
TECHNICAL SPECIFICATIONS:
Color: Black
Dimensions: Lantern light:12.7cm(L)*12.7cm(W)*26.4cm(H);
Wall mounted: 13.6cm(L)*13.6cm(W)*2.2cm(H)
Product weight: 0.522KGS
Material: Plastic
Solar panel: Solar Panel 55*75mm
Battery: 1.2V 1200MAH AA 1PC NI-MH rechargeable battery
Voltage: 2V, 0.3W
Current: 220mA
Lumen: 15 Lumens
Color temp: 2800-3200K
LED: 1pc filament LED
Water resistance: IP44
Charging time: 6-8 hours of sunlight averagely
Operating time: 8 hours on a full battery
Switch: pull tag
© 2021 The Investment Company Europe B.V. HYUNDAI is a
trademark of HYUNDAI Corporation Holdings, Korea. Licensed to The
Investment Company Europe B.V. All rights reserved.
Licensed by HYUNDAI Corporation Holdings, Korea. Imported/
Distributed by The Investment Company Europe B.V. exclusively
developed for sales in the Netherlands, Belgium, and Luxembourg.
The artwork and design of this package are protected by European
copyright law and may not be reproduced, distributed, displayed,
published or used for any purpose without prior written permission.
It is not permitted to alter, or reproduce any trademarks or copyright
User Manual
PATENT PENDING
notice from this package.
NL / EN - www.alleenonline.nl
BE / FR - www.alleenonline.be