3.
Remove the two screws on top of the metal cover (1), and pull
the metal cover upwards (2).
Closing the printer
1.
Align and insert the protrusion at the bottom of the metal
cover into the notch of the printer (1), and tighten the two
screws on the top of the cover (2).
2.
Align and insert the protrusions at the top of the right
detachable cover into the notches of the printer (1). Fit the
protrusions at the bottom of the cover into the printer (2) and
slide the cover towards the front of the printer (3).
3.
Tighten the screw on the right detachable cover.
INSTALLATION AND RELOCATION PROCEDURE > 27