HP E3800-24G-2SFP+ Installation And Getting Started Manual page 65

Figure 3-1. Example CLI switch setup screen
4. Use the Tab key to select the Manager Password field and enter a manager
5. Tab to the IP Config (DHCP/Bootp) field and use the Space bar to select the
6. Tab to the IP Address field and enter the IP address that is compatible with
7. Tab to the Subnet Mask field and enter the subnet mask for your network.
8. Press Enter, then S (for Save).
The following fields are displayed in the Setup screen. For more information
on these fields, see the Management and Configuration Guide, which is on
the HP Web site at www.hp.com/networking/support.
Parameter Default
System Name blank
System Contact blank
Manager Password blank
Logon Default CLI
Time Zone 0 (none)
password of up to 16 characters.
Manual option.
your network.
Optional; up to 25 characters, including spaces
Optional; up to 48 characters, including spaces
Recommended; up to 16 characters (no blank spaces)
The default setting selects the command line interface for console access.
The alternative is the menu interface.
Optional; 1440 to -1440. The number of minutes your location is to the West (-)
or East (+) of GMT.
Getting Started With Switch Configuration
Minimal Configuration Through the Console Port Connection
3-3