Meter Specifications For 3415, 3416 And 3417 Models - Emerson Rosemount 3410 Series Reference Manual

Introduction
January 2023
Note
The optional LCD Display requires firmware v1.04 or later and Uboot version, January 31,
2013.
The Base Electronics Enclosure that houses the Acquisition Module. Intrinsically safe
transducers and cable assemblies are designed for Class 1, Division1, Groups C and D
areas without need of further protection when installed in accordance with the field wiring
diagram (refer to Rosemount drawing DMC-005324 see
1.6 Meter specifications for 3415, 3416 and 3417
models
WARNING
CONTENTS MAY BE UNDER PRESSURE
When the meter is under pressure, DO NOT attempt to remove or adjust the transducer
holder of the T-Slot transducer assembly, or loosen the screws holding the T-200
transducer assembly.
Attempting to do so could release pressurized gases, resulting in serious injury or
equipment damage.
WARNING
CONTENTS MAY BE HAZARDOUS
The meter must be fully depressurized and drained before attempting to remove the T-200
transducer assembly. If gas or fluid begins to leak from the T-200 transducer stalk
assembly, stop immediately and reinstall T-200 stalk assembly.
Failure to comply could cause serious injury or equipment damage.
A. Transducer holder
14
Reference Manual
00825-0200-3104
3410 Series engineering
Emerson.com/Rosemount
drawings).