Mechanism Adjustment - Pioneer XV-DV358 Service Manual

5

6.5 MECHANISM ADJUSTMENT

Tangential and Radial Height Coarse Adjustment
1
START
• Remove the 06SD Pickup Assy from the Traverse Mechanism Assy-S.
• Remove the joint and the joint spring of the 06SD Pickup Assy.
Note:
Before removing the flexible cable for the
pickup, soldering of the pickup circuit is
necessary.
For details, see "7.1.13 DISASSEMBLY".
• Pass through the guide shaft to a new 06SD Pickup Assy.
• Attach it to the Traverse Mechanism Assy-S.
• Put the joint between the Tangential (or Radial) adjustment screw and the mechanism base
and turn each screw to adjust the height.
(Refer to "6.1 ADJUSTMENT ITEMS AND LOCATION".)
• Attach the Traverse Mechanism Assy-S to the 06 LOADER Assy.
• Turn it over and attach the joint and the joint spring.
• Arrange the flexible cables.
(Refer to "7.1.13 DISASSEMBLY".)
5
6
Guide Shaft
XV-DV353
6
7
06SD Pickup Assy
Joint VK1B
Joint spring VK1
Hold spring
06SD Pickup Assy
Joint
7.5mm
Mechanism base
7
8
A
B
C
D
E
F
65
8