Sk1-Sub-Key Board, Button (Power-Cz2); Sk1-Sub-Jack Board - Sony SA-WX9000F Service Manual

2-7.

SK1-SUB-KEY BOARD, BUTTON (POWER-CZ2)

3 Remove the SK1-SUB-KEY board
block in the direction of the arrow.
1 SK1-SUB-JACK board cable
connector (CN8601)
5 SK1-SUB-KEY board
Note 1: When installing the SK1-SUB-KEY
board, align the two bosses and two
holes.
2 two screws
(BVTP3
< Fig. B >
SK1-SUB-KEY board (side A)
push switch
2-8.

SK1-SUB-JACK BOARD

1 SK1-SUB-KEY board cable
2 SK1 SUB MAIN board cable
connector (CN8504)
– –
bracket
(jack)
Installation direction for
the lug terminal.
4 wire with lug
6 Remove the button block in
the direction of the arrow.
8)
hole
front side
hole
SK1-SUB-KEY board (side A)
non woven fabric (T0.3)
connector (CN8508)
front side
hole
hole
5 SK1-SUB-JACK board block
Note 1: When installing the SK1-SUB-JACK
3 screw
(BVTP3 8)
AMP block
7 two non woven
fabrics (T0.3)
(See Fig. C)
total six holes
8 button (power-CZ2)
Note 2: When installing the button (power-CZ2),
align the six bosses and six holes.
4 two non woven fabrics (T0.3)
(See Fig. B)
< Fig. C >
guide line
(center)
guide line
two non woven fabrics (T0.3)
top side
board block, align the two bosses and
two holes.
SA-WX9000F/WXF9000
top side
three bosses
– Rear view –
guide line
(center)
button (power-CZ2)
guide line
AMP block
8 SK1-SUB-JACK board
Note 2: When installing the
SK1-SUB-JACK board,
align the two ribs and
two holes.
boss
6 two screws
rear side
hole
boss
rib
7 bracket (jack)
three
bosses
rear side
boss
boss
(BVTP3 8)
hole
rib
11