Installation
The holes for securing the
connecting bracket have to be
pre-drilled.
Push the connecting bracket with
cut-outs over the holders for the
wall spacers.
Use a pen to mark the position of the
drill holes.
Then take the connecting bracket
off again.
Drill through the panel only. Drilling
depth approx. 1 mm.
Drill the screw holes with a 3 mm drill
bit and then file any rough edges
smooth.
11210830-03
Place the connecting bracket so
that the horizontal long slot is on the
left hand side and secure it as
follows:
1. Secure it loosely with the screw .
2. Adjust the connecting bracket until
its centre piece abuts against the
side of the second appliance.
3. Secure the connecting bracket
using the screw .
4. Now tighten the loose screw and as
you do so push the right hand
appliance up against the left hand
appliance.