Table of Contents
Advertisement
Cutting Angle Adjuster
(Figure 6)
Controls the cutting angle of the blade for
decorative edging.
1. Push the lever forward to unlock the
head and then rotate it left or right to set
the desired edging angle.
Push the lever forward slightly to unlock
the head.
Rotate the head to the desired angle.
Make sure the lever locks into place.
Figure 6
NOTE: The head pivots from about
80 degrees to 110 degrees.
IMPORTANT: Make sure the front wheel
does not contact the blade when angling the
blade for a beveled edge.
Rear Wheel Height Adjuster
(Figure 7)
Sets the rear wheel height to support the
edger when working along curbs or other
uneven terrain.
1. Loosen the knob and position the wheel
so it supports the unit level when
operating, and then securely tighten the
knob.
NOTE: Set the wheel height before starting
the engine or engaging the blades.
Loosen knob,
position wheel
at the desired
height and
replace the
knob.
EN - 9
Figure 7
Advertisement
Table of Contents
