Levelling And Securing The Dishwasher; Floor Anchoring - Miele PFD 401 Marine Operating Instructions Manual

Installation
Levelling and securing the
dishwasher
To guarantee stability, the dishwasher must
be secured to the worktop after levelling.
After levelling, secure the dishwasher to

the continuous worktop.
With the door open, screw into the
worktop through the holes in the front trim
on the left- and right-hand sides of the
dishwasher.
With stainless-steel or stone worktops, the
dishwasher must be secured at the sides to
the left and right adjacent cupboards with
two screws on each side.
Special screws (4 x 27/Torx T20) are
supplied in the accessory pack.
Holes must be drilled in the side wall in front
of the door seal for this.
In the case of built-under dishwashers, the
holes are already provided in the side walls.
The gaps between built-under dishwashers
and adjacent cabinets or machines must
not be filled with silicone sealant as this
could compromise the ventilation of the
circulation pump.
96
Depending on the specific built-under
installation situation, the stainless steel
cover plate supplied can be attached to the
lower edge of the worktop. The stainless-
steel cover plate protects the lower edge of
the worktop against steam damage.

Floor anchoring

The dishwasher must be prevented from
tilting or moving by anchoring both rear
machine feet to the floor.
Fix the floor anchoring to the floor at the

same distance as the two rear machine
feet using the anchoring kit supplied.
If necessary, adapt the anchoring to the

respective ground conditions on site.
Slide the dishwasher into the designated

holder of the floor anchoring.