Assembly; Discharge Cap Assembly; Chute Assembly; Attach Chipper Chute (Ce Compliant Models) - Echo BEAR CAT CH45540 Owner's Manual

2

ASSEMBLY

Section
WARNING
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.

2.1 DISCHARGE CAP ASSEMBLY

1. Move the chipper deflector weldment located inside
the chipper housing to the down position (Figure 2.1).
Figure 2.1, Chipper Deflector Weldment
2. Slide the discharge cap onto the chipper housing
(Figure 2.2).
Figure 2.2, Discharge Cap
3. Insert two 3/8" × 5-1/2" bolts into the bolt holes on the
chipper housing and tighten using 3/8" washers and
3/8" nylock nuts.

2.2 CHUTE ASSEMBLY

Attach the chipper chute to the chipper housing using four
3/8" × 1" carriage bolts, washers and locknuts (Figure
2.3). Use two bolts on each side. Install with nuts on the
outside.
2.3 ATTACH CHIPPER CHUTE
(CE COMPLIANT MODELS)
Attach the chipper chute extension to the chipper chute
using six 3/8" × 1" carriage bolts, 3/8" washers and 3/8"
nuts (Figure 2.4). Use three bolts on each side.
3/8 X 1"
CARRIAGE
BOLTS
Figure 2.4, Chipper Chute Extension
4.5 INCH CHIPPER
Figure 2.3, Chipper Chute
CHIPPER CHUTE
CHIPPER
CHUTE
EXTENSION
5