Table of Contents
Advertisement
ASSEMBLY
2.4 CONNECT TO PTO DRIVELINE
The driveline supplied with this machine may need to be
cut to a shorter length for proper operation with the tractor
being used. To determine if driveline will need to be cut,
follow steps below or consult attached driveline manual.
1. BEFORE ATTACHING THE DRIVELINE: attach the
machine to the tractor with three-point hitch system.
2. Raise and lower machine on three-point hitch to
determine the shortest possible working distance
between the tractor PTO shaft and the drive shaft of
the machine.
3. Pull the driveline apart so the two pieces are
separated. Attach the 6-splined connector for the
outer tube to the tractor, and attach the connector for
the inner tube to the machine.
4. Position installed driveline halves parallel to one
another. (Photo below is example of driveline overlap.)
5. On larger outer tube, measure back 1-1/4" (32 mm)
from lower yoke shield and mark plastic tube. Repeat
this process for smaller inner plastic tube measuring
1-1/4" (32 mm) back from upper yoke shield.
Outer
Tube
1-1/4" from Shield
6
Yoke
Shield
1-1/4" from Shield
Yoke
Shield
Inner
Tube
4.5 INCH CHIPPER
IMPORTANT
●
The tractor must have a standard 540 RPM PTO
shaft.
●
If the tractor has an electric PTO clutch, consult
your dealer for correct operating procedures.
●
Consult the attached GKN Walterscheid driveline
manual for complete service and maintenance
recommendations.
6. Remove driveline pieces (for ease of cutting) and cut
ONLY the outer and inner plastic tubes.
7. After cutting plastic tubes, measure 1-9/16" (40 mm)
from the ends of both newly cut plastic tubes.
8. Mark the inner steel shafts and cut both shafts at
1-9/16" (40 mm) as shown in the photos.
Steel
Shaft
1-9/16" (40 mm)
Steel
Shaft
9. File both shaft ends to remove sharp edges and slide
the driveline pieces back together.
10. When you have confirmed that the driveline is the
correct length for your tractor, connect the driveline to
the chipper rotor.
11. Connect the opposite end of the PTO shaft to the
tractor.
2.5 CONNECT CONTROL BOX WIRES
TO TRACTOR
There are two electrical wires (red and white) that come
wrapped around the three-point PTO connector.
●
Connect the red wire to a 12-volt power source, such
as the alternator or the battery.
●
Ground the white wire (connect to negative post on
the battery or another point).
Outer
Tube
Inner
Tube
Advertisement
Table of Contents
