SYSTEM OPERATION
ID Plugs for ULN Gas Package Units
Each 80% ULN model has a unique ID Plug that needs to
be installed into the board for your specific model number.
The ID Plug will populate the board with the correct
operating parameters for each model and should be left on
the board once installed.
Please see the table below for reference:
Part Number
0130G00012
0130G00013
0130G00014
Goodman / Amana
*PUM3**040M41AA
*PUM3**060M41AA
*PUM3**080M41AA
ID Plug Installation
The following procedure will ensure the proper operating
parameters are installed onto the board. Each model has a
unique ID PLUG that needs to be installed onto the board.
Please see the instructions below:
1. Select the appropriate ID plug for the installed model
number from the table above.
2. Attached the appropriate ID plug for the installed
model number to the control board into the blue
connector as shown below. This will load the correct
parameters to the board. Failure to follow these
instructions will result in the board not functioning.
8