Assembly - Gravely Pro-Stance 48 Owner's/Operator's Manual

WARNING:
and understand entire Safety
section before proceeding
UNIT ASSEMBLY
Package Contents:
Unit, Mower Deck and Literature Pack
Preparation Checklist
Refer to the Owner/Operator manual as
required.
1. Unpack Unit – Remove wrap and
packaging materials.
2. Remove Unit From Container – Open
bypass valves (See To Push The Unit on
page 18).
3. Push unit from container onto a level
surface.
4. Close the bypass valves.
Check Tire Pressu
5.
Specifications on page 35.
CAUTION:
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a tire
without the proper equipment
and experience to perform the
job.
• Do not inflate the tires above
the recommended pressure.
• Do not weld or heat a wheel
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or deform
the wheel.
• Do not stand in front or over
the tire assembly when
inflating. Use a clip-on chuck
and extension hose long
enough to allow you to stand
to one side.
6. Unlock and lower operator platform into
operating position.
7. Set the speed control bar (item 2) to
desired operating position and tighten
speed control bar lock (item 1)
(Figure 3).
8. Check Steering Lever Positions – See
Steering Lever Adjustment on page 25.
9. Charge Battery – Remove battery from
unit and charge (See Battery on
page 24).

ASSEMBLY

AVOID INJURY. Read
.
res – See
Avoid injury! Explosive
10. Check Engine Oil Level – Check and
add oil if needed. See engine manual for
specifications.
11. Check Hydraulic Fluid Level – Check
and add oil if needed. See Check
Hydraulic Fluid Level on page 21.
12. Fill Engine Fuel Tank – Add clean fuel to
the fuel tank. See Filling Fuel Tank on
page 16.
IMPORTANT: Refer to engine manual for fuel
type.
13. Inspect Hardware – Check for loose
hardware.
14. Check Safety Interlock System – Check
to see that the interlock system operates
correctly (See Safety Interlock System
on page 13).
1. Speed Control Bar Lock
2. Speed Control Bar
WARNING:
INTERLOCK together with improper
operation can result in severe
personal injury.
15. Lubrication – Lubricate all fittings per
maintenance schedule and check
hydrostat oil level (See Maintenance
Schedule on page 19).
16. Remove the knob retaining the
discharge chute from the transport
position and place the discharge chute
in the operating position. Return and
tighten knob in original position on deck
for storage (Figure 4).
EN - 10
2
Figure 3
FAILURE OF
1