Clip Calling Line Identification Report; Cme Error Mobile Equipment Error; Colp Connected Line Identification Report; Cr Data Service Report - Nokia 8210 Command List
At command set
Hide thumbs
Also See for 8210:
- User manual (82 pages) ,
- Quick manual (6 pages) ,
- Connection manual (4 pages)
Table of Contents
Advertisement
+CKEV Keypad Event
+CLIP Calling Line Identification Report
+CME ERROR Mobile Equipment Error
+COLP Connected Line Identification Report
+CR Data service report
+CREG Network Registration
AT Command Set for Nokia 8210
+CKEV: <key>,<press>
- when +CMER=2:
only last indication of each <key> value is buffered if in on-line data state
- when +CMER=3 and V.80 in-band mode is enabled:
all events are forwarded directly to TE
- when +CMER=3 and V.80 in-band mode is disabled or not supported:
behaves like +CMER=2 case
See also command +CMER, page 21. (GSM 07.07 section 8.10).
+CLIP: <number>,<type>[, <subaddr>,<satype>[,<alpha>]]
is given when +CLIP=1 and and number received from network when MT call
received (no active or held calls in ME).
This result code is sent to TE after every RING (or +CRING) result code. Subaddress
and alpha not supported by NMP products. (GSM 07.07 section 7.6).
+CME ERROR: <err>
is given instead of ERROR when +CMEE=1 or =2 and error is related to ME or
network operation.
See also the Error Values section, page 56. (GSM 07.07 section 9.2).
+COLP: <number>,<type>[,<subaddr>,<satype>[,<alpha>]]
is given when +COLP=1 and number received from network when MO call
established.
This intermediate result code is given after (possible) +CSSI result code. Subaddress
and alpha not supported by NMP products. (GSM 07.07 section 7.8).
+CR: <type>
is given when +CR=1 and data call established; informs about the type of data call
being established.
This intermediate result code is given after (possible) +COLP result code during MO
data call setup. During MT data call setup this is the first intermediate result code.
Note that this result code shall replace CARRIER result code (when X5 is set). (GSM
07.07 section 6.9).
+CREG: <stat>[,<lac>,<cid>]
- when +CREG=1:
given when <stat> value changes; given after NO CARRIER if network lost when on-
line
- when +CREG=2:
given when <stat> value changes and when network cell (<lac> and <cid>) of ME
changes; given after NO CARRIER if network lost when on-line; if V.80 is enabled,
result code is sent in-band during on-line data mode
(GSM 07.07 section 7.2).
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
67
Advertisement
Table of Contents
