B Communications Standard Option (Ccitt/Bell Mode); D Dial - Nokia 8210 Command List

B Communications Standard Option (CCITT/Bell mode)

D Dial

AT Command Set for Nokia 8210
Result Codes
possible verbose
result codes (V1)
CONNECT
CONNECT 1200
CONNECT 2400
CONNECT 4800
CONNECT 9600
CONNECT 14400
CONNECT 19200
CONNECT 28800
ERROR
NO CARRIER
OK
This command has no effect on the data software. It is included for compatibility
reasons. (De facto.)
Syntax:
ATB[<n>]
This command initiates a call. (V.25ter section 6.3.1.) When a call is initiated, the
command must contain the called party's number or a directory entry which contains
the stored number. The ATD command can also be used for sending DTMF tones
and for switching call mode from voice to data when an alternating call is active.
(GSM 07.07 section 6.6 and annexes E and F)
When the product tries to reach a number and fails to establish a connection, further
attempts will be delayed, i.e., successive attempts to dial the same number will be
rejected for a short period of time, and the response DELAYED will be displayed. The
delay period only lasts for a few seconds at first, however, if you continue to try to get
the call through and fail, the delay will be prolonged for a few minutes. Finally, the
called number will be included on a list of so-called blacklisted numbers. The
response BLACKLISTED will be seen on the screen. The data software will not
accept any new attempts to that number before you press any key on the cellular
phone keypad. This user action erases the number from the list and enables you to
call the number again. The purpose of blacklisting numbers is to conserve the
network's resources.
NOTE: +VTS command or comma modifier (e.g. "ATD,1234"; in this case the first
comma do not cause a pause) can be used to send DTMF digits.
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
numeric
(V0) description
1 data/fax call established; rate 300 bps (or X
forbids rate display)
5 data/fax call established; rate 1200 bps
10 data/fax call established; rate 2400 bps
11 data/fax call established; rate 4800 bps
12 data/fax call established; rate 9600 bps
17 HSCSD (or 14.4 tch) data/fax call established;
rate 14400 bps
18 HSCSD data/fax call established; rate 19200 bps
19 HSCSD data/fax call established; rate 28800 bps
4 command cannot be actioned
3 call could not be established
0 command aborted
Values for <n> [0]...1.
46