Table of Contents
Advertisement
Precautions for Correct Use
Installation Location
In order to prevent the product from becoming inoperable or malfunction, and to prevent other
adverse effects to the performance or equipment, please observe the following.
• A location where the ambient temperature does not exceed the rated range.
• A location where the temperature does not vary sharply (condensation occurs).
• A location where relative temperature does not exceed a range of 35-85%.
• A location not exposed to corrosive gases or combustible gases.
• A location not exposed to dust, salt, or metal powder.
• A location not exposed to direct vibration or impact.
• A location not exposed to strong disturbance light (laser light, arc welding light, or ultraviolet
light).
• A location not near a heating appliance or exposed to direct sunlight.
• A location not exposed to mist of water, oil, or chemicals or misty atmosphere.
• A location not exposed to strong magnetic/electric fields.
• A location not near a high-voltage device or power device.
• A location where rubber quality is not deteriorated.
MicroSD Card Handling
• If removing the microSD card, confirm that data are not being read or written before removing
it.
• Do not insert the microSD card inversely, obliquely, or as twisting it.
• While data are being read in or written to the microSD card, the SD ACCESS LED on the
smart camera main unit is turned on for a while. Remove the card after checking that the LED
is completely turned off.
• Except when inserting or removing the microSD card, put the cover of the microSD card in-
serting connector and screw it up before using the product.
Camera Installation
• In a hot and humid environment, Condensation may occur if stored, assembled, or used.
If cloudy, remove the lighting cover or water-proof hood and wipe off the inside with a soft
cloth.
If condensation remains, keep the product under normal temperature and normal humidity
(around 25°C and 50%RH) with its power ON for about two hours before assembling the wa-
terproof hood and lighting module.
• If installing smart camera main units side by side, secure a space of 30 mm or more wide
between them.
FHV Series Smart Camera Setup Manual (Z408-E1)
4 Handling and Installation Environment
4
4-3
Advertisement
Table of Contents
