Memory Card Installation; Insert A Microsd Card; Remove The Microsd Card - Nokia 6126 User Manual

For availability of approved enhancements, please check with your dealer. When you disconnect
the power cord of any enhancement, grasp and pull the plug, not the cord.
1. Connect the charger to a standard wall outlet.
2. Insert the charger plug into the jack on the bottom of
the phone. If the battery is completely discharged, it
may take a few minutes before the charging
indicator appears on the display or before any calls
can be made.
3. Disconnect the charger from the phone when the
battery is fully charged.
You can use the phone while the charger is connected. The charging time depends on the
charger used. Charging a BL-4C battery with the AC-3 charger takes approximately 2 hours
and 20 minutes while the phone is in the standby mode.
■

Memory card installation

Keep all microSD memory cards out of the reach of small children.
Use only compatible microSD cards approved by Nokia for use with this device. Nokia uses
approved industry standards for memory cards, but some brands may not be fully compatible
with this device. Incompatible cards may damage the card and the device and corrupt data
stored on the card.
You can insert or change the memory card without turning the phone off.

Insert a microSD card

1. Remove the back cover of the phone.
2. Insert the card into the microSD card slot with the
gold-colored contact surface facing down, and press
it until it locks into place.
3. Close the back cover of the phone.

Remove the microSD card

Important: Do not remove the memory card in the middle of an operation when the
card is being accessed. Removing the card in the middle of an operation may damage
the memory card as well as the device, and data stored on the card may be corrupted.
1. Make sure that no application is accessing the microSD memory card.
2. Remove the back cover of the phone.
3. Press the microSD card slightly in to release the lock.
4. Remove the microSD card from the slot.
11