Charge The Battery; Antenna; Headset - Nokia 5300 User Manual

damage the memory card as well as the device, and data
stored on the card may be corrupted.
You can remove or replace the microSD card during phone
operation without switching the device off.
1. Make sure that no application is currently accessing the
microSD memory card.
2. Remove the back cover of the device.
3. Press the microSD card slightly in to release the lock
and remove it.

Charge the battery

Check the model number of any charger before use with
this device. This device is intended for use when supplied
with power from the AC-3 and AC-4 charger.
Warning: Use only batteries, chargers, and
enhancements approved by Nokia for use with this
particular model. The use of any other types may
invalidate any approval or warranty, and may be
dangerous.
For availability of approved enhancements, please check
with your dealer. When you disconnect the power cord of
any enhancement, grasp and pull the plug, not the cord.
1. Connect the charger to a wall socket.
2. Connect the lead from the
charger to the charger
connector of your phone.
If the battery is completely
discharged, it may take a few
minutes before the charging
indicator appears on the display
or before any calls can be made.
The charging time depends on
the charger used. Charging a BL-4CT battery with the AC-3
charger takes approximately 2 hours 30 minutes while the
phone is in the standby mode.

Antenna

Note: As with any radio transmitting
device, avoid touching an antenna unnecessarily
when the antenna is in use. For example, avoid
touching the cellular antenna during a phone call.
Contact with a transmitting or receiving antenna
affects the quality of the radio communication,
may cause the device to operate at a higher
power level than otherwise needed, and may
reduce the battery life.
The picture shows the antenna area marked in grey.

Headset

Warning: Listen to music at a moderate level.
Continuous exposure to high volume may damage your
hearing.
11