Advertisement
Quick Links
VIVOTEK Fixed Dome Series
Wall-mount Bracket
Using AM-218 wall-mount bracket
and compatible accessories
Installation Guide
Corresponding part numbers:
AM-218: 100146100G
AM-714: 625031000G
AM-520: 900020102G (v03)
AM-525: 100140500G
AM-527: 100140400G
AM-528: 100147800G
AM-312: 900034800G
AM-412: 900034900G
Rev. 1.0
Part no. for this document:
625035000G
IP Sur veillance
Advertisement
Related Manuals for Vivotek Fixed Dome Series
Summary of Contents for Vivotek Fixed Dome Series
- Page 1 VIVOTEK Fixed Dome Series Wall-mount Bracket Installation Guide Using AM-218 wall-mount bracket and compatible accessories Corresponding part numbers: AM-218: 100146100G AM-714: 625031000G AM-520: 900020102G (v03) AM-525: 100140500G AM-527: 100140400G AM-528: 100147800G AM-312: 900034800G AM-412: 900034900G Rev. 1.0 Part no. for this document:...
- Page 2 FD8361 / FD8361L / FD8362 /FD8362E / FD8363 / FD8335H/ FD8372 / FD8162 / FD8135H / FD8163 / FD8131V / FD8133V/ FD8134V / FE8172V Fixed Dome series / FE8171V / FE8174/ FE8174V / FE8181 / FE8181V / MD7530 / MD7560...
-
Page 3: Installation
For details about mounting cameras to the AM-520, AM-525, and AM-527 brackets, refer to their Installation Guides. For cabling and configuration details with each network camera, please refer to their documentation. Installation IMPORTANT: The AM-218 has to be installed with the AM-714. You should also purchase the AM-214 conduit box and corresponding AM-520, AM-525, and AM-527 adapter. -
Page 4: Wall Mount Installation
Refer to the table below for the description of the included screws: Screw Description No. of Material char. screws M5X14 Stainless steel, hex and cross head NOTE: 1. It is presumed that this wall-mount bracket is installed with a hole drilled on the wall for routing power lines, DI/DO, and Ethernet cables. - Page 5 A 3/4" conduit is required for routing the cables with waterproof connection. Install the cable gland and pass cables through it. Form a drip loop when routing with the conduits.
- Page 6 Installing the Bracket and Adapter 1. Route cables through the AM-218 bracket and the adapter (AM-520/AM-525/AM-527/ AM-528). 2. Secure the bracket to the conduit box using the included hex screws. 3. Secure the adapter by turning them clockwise. When done, fasten the hex socket screw to secure the connection.
- Page 7 4. Follow the instructions in the Installation Guide that came with the adapter to install network cameras.
- Page 8 Pole mount and corner mount are also supported. Please refer to their Installation Guides for more information. AM-312 AM-412...