Vivotek AM-715 Installation Manual

VIVOTEK Mounting Accessories
AM-412 Corner mount
Installation Guide
Revision History:
Rev. 1.0: Initial release
Corresponding ordering part numbers:
AM-412: 900034900G AM-714: 100134800G
AM-715: 100134700G AM-218: 100146100G
I Compatible VIVOTEK Cameras
Compatible Supported Cameras
accessories
AM-714 IB836B-HF3/6B-EHF3, IB836B-HT/6B-EHT, IB9371-HT/71-EHT, IB8382-F3/82-EF3,
IB8382-T/82-ET, IB9381-HT/81-EHT, IB9371-HRT, IB9381-HRT
AM-715 IB8367/67-R, IB8367-T/67-RT, IB8338-H/38-HR
AM-218 (via AM-714) Please refer to AM-218 documents.
Directly attached Supported Cameras
* IB836B-HF3/6B-EHF3, IB836B-HT/6B-EHT, IB9371-HT/71-EHT, IB8382-F3/82-EF3,
IB8382-T/82-ET, IB9381-HT/81-EHT, IB9371-HRT, IB9381-HRT
* The directly-attached configuration is less recommended for the lack of waterproof and cabling
protection. If directly attached, you should properly wrap the rear-end cables and connectors with
waterproof protection such as putties.
Package Contents
Items 1. Corner mount bracket, 2. M6X20mm screws x4. 3. M5X20mm screws x4, 4. Hex L
wrench 5mm x1, 5. Hex L wrench 4mm x1, 6. M9 nut x2.
Installation
III
Below is a general, sample procedure using a Corner mount bracket:
1. Combine the two metal pieces together using the M8 hex nuts and washers.
2. Align the assembled brackets with the desired position. Align screw holes on the brackets against the wall. Drill
holes on the wall for securing the bracket and for routing the cables. Hammer the anchors into the wall. Note
that these screws and wall anchors are user-supplied.
3. The 4 screw holes in the center are used for directly mounting the IB series bullet cameras.
The 4 screw holes at the edges are used for mounting the AM-714 conduit box.
For M6 socket screws
- for IB series bullet cameras
directly attached
X4
M6X20 X4 M5X20
M8 X2
X1
4mm
5mm X1
x8
For M5 socket screws
- for AM-714 conduit box
II Mechanical Drawings
AM-412 Corner mount bracket
M8X20mm
SUS 302
6
7
45
86
102
315,25
AM-412 Applications
AM-714
AM-218
AM-520 / AM-525, etc.
Dome camera
4. Secure the AM-714 conduit box to bracket using the M5 screws, washers, and hex heads. A hex crescent
wrench is required.
M5
5. For the rest of the installation procedure, refer to the documentation that came with the AM-714, AM-715, AM-
218, and the other accessories.
The 3/4" cable glands and conduts for protecting cables are user-supplied.
215,71
AM-714
- or -
AM-412
AM-715
Bullet camera
AM-412