Collecting Bag For Sandblasting Material; Troubleshooting; Maintenance And Cleaning - Parkside PDSP 1000 E6 Translation Of The Original Instructions

Collecting bag for sandblasting
material
NOTE
► Do not re-use surplus sand-blasting material
from the collecting bag
■ You can remove the surplus sand-blasting mate-
rial which has collected in the collecting bag
via the zip fastener or use a screwdriver to undo
the screw clamp
bag from the appliance.

Troubleshooting

Fault/possible cause Remedy
No material flow
The air is not dry
enough.
Air pressure too low
Attachment not sitting
correctly
Blocked sand-blasting
material pipes
■ 36 │ GB │ MT
.
and remove the collecting
Install a water separator
in your compressed air
system.
Increase the output
pressure of your
compressor.
Ensure that the attach-
ment is firmly on the
appliance and that no
air escapes at the sides.
Check that no lumps of
sandblasting material
are blocking the pipes.
Preferably, use a blow-
out gun to clean
blocked pipes.
(Wear safety
goggles!) Also check
the tank outlet opening.
Fault/possible cause Remedy
Sand-blasting pattern not as expected
The air is not dry
enough.
Sand-blasting material
grain size not uniform
Sand-blasting material
impure
The attachment is worn Replace the attachment
Other defects
Please contact an expert or your retailer.

Maintenance and cleaning

WARNING! RISK OF INJURY!
ALWAYS disconnect the appliance
from the compressed air supply
before cleaning it.
■ Always clean the compressed air sandblaster
gun and the blasting medium container
immediately after completing your work. To do
this, blow out the compressed air sandblaster
gun and the blasting medium container
with compressed air.
■ Store the compressed air sandblaster gun
only in dry rooms.
Install a water separator
in your compressed air
system.
Replace sand-blasting
material.
Replace sand-blasting
material
PDSP 1000 E6