Before you begin
Read all instructions before set up.
Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
Do not set up your tent under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
Secure with all stakes and guylines provided to prevent
property damage or personal injury.
For best results in windy conditions, position narrow end of
tent into the wind.
Enlist the help of at least one other person to assist you
when it is time to assemble the tent.
Pole Descriptions
No.
Description
1
Main Body Pole, black, long
2
Ridge Pole, black, short
1
Layout & Positioning
of Tent and Poles
Layout and position the tent with door facing desired
direction. (Fig. 1)
Stake down tent corners first through the stake rings. (Fig. 2)
Keep the floor taut.
Stake down the remainder of the stake rings.
Assemble all poles by unfolding and interlocking the shock-
corded pole sections.
Insert the body poles into the pole sleeves.
Pole
Sleeve
Fig. 1
Tent
Stake
Fig. 2
TENT SETUP INSTRUCTIONS
Qty.
Pole
Pole
Repair Kit
Replacement Kit
2
5010000539
5010000549
1
5010000539
5010000549
1
Stake Ring
MODEL 2000007826
2
Connect Poles to Tent
Insert one pin into one end of the pole. (Fig. 3 and 4)
Go to opposite end of pole and carefully insert the pin into the
other pole end. (Fig. 4)
Repeat for all poles.
Fig. 3
Pole
Pin
Fig. 4
3
Attach Tent to Body Poles
Using Clips
Attach clips along the edges of tent to body poles. (Fig. 5)
Make any adjustments to the tent stakes, if needed.
4
Attach Rainfly
Attach top ridge pole to underside of rainfly with straps and
insert the tips of the top ridge pole into the pockets on underside
of rainfly. (Fig. 6 & 7)
Drape rainfly over tent. (Fig. 8)
Connect the elastic loops with "S" hooks, (found at the rainfly
corners) to the rings found at the tent corners. (Fig. 9)
Secure rainfly with straps located on the underside of
rainfly. (Fig. 10)
Attach and stake out elastic cord at ground vent and
guylines. (Fig. 8)
HINT: During setup, keep door zipped to keep proper tension
on fabric.
Pole
Clip
Fig. 5
(continued on other side)