Intended Use - Ryobi RRT4 Manual

Safety, performance, and dependability
have been given top priority in the
design of your rotary tool.

INTENDED USE

The rotary tool is intended to be used
only by adults who have read and
understood the instructions and warnings
in this manual, and can be considered
responsible for their actions.
With appropriate accessories fi tted,
the product is designed to perform
grinding, sanding,
sculpting, polishing, buffi ng, etching and
engraving.
The product is intended for consumer
use only.
Do not use the product for any other
purpose. Use of the product for
operations different from intended could
result in a hazardous situation.
WARNING! Read
warnings, instructions, illustrations
and specifications provided with
this power tool. Failure to follow all
instructions listed below may result in
electric shock, fi re and/or serious injury.
Save all warnings and instructions
for future reference.
ROTARY TOOL SAFETY WARNINGS
Safety warnings common for
grinding, sanding, wire brushing,
polishing, carving or abrasive cutting-
off operations
■ This power tool is intended to
function as a grinder, sander, wire
brush, polisher, carving or cut-off
tool. Read all safety warnings,
instructions, illustrations
specifications provided with this
power tool. Failure to follow all
■
■
rust removal,
■
■
all safety
■
■
and
instructions listed below may result
in electric shock, fire and/or serious
injury.
Do not use accessories which
are not specifically
and recommended by the tool
manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
The rated speed of the grinding
accessories must be at least
equal to the maximum speed
marked on the power tool. Grinding
accessories running faster than their
rated speed can break and fly apart.
The outside diameter and the
thickness of your accessory must
be within the capacity rating of
your power tool. Incorrectly sized
accessories cannot be adequately
controlled.
The arbour size of wheels, sanding
drums or any other accessory
must properly fit the spindle or
collet of the power tool. Accessories
that do not match the mounting
hardware of the power tool will run
out of balance, vibrate excessively
and may cause loss of control.
Mandrel mounted wheels, sanding
drums, cutters or other accessories
must be fully inserted into the
collet or chuck. If the mandrel is
insufficiently held and/or the overhang
of the wheel is too long, the mounted
wheel may become loose and be
ejected at high velocity.
Do not use a damaged accessory.
Before each use
accessory such as abrasive wheels
for chips and cracks, sanding drum
for cracks, tear or excess wear,
wire brush for loose or cracked
wires. If power tool or accessory
is dropped, inspect for damage or
Original Instructions
designed
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
inspect the
3