Charging Dana; Dana First Time Set Up - Alphasmart Dana Getting Started

Charging Dana

Dana comes with a rechargeable battery pack that recharges whenever it
is connected to its AC Adapter or a USB port on your computer (charg-
ing while the computer is on). You can also use standard AA alkaline
batteries (not included).
You will need to connect Dana to the AC adapter for four hours or the
computer for eight hours to get a full charge. Use the AC adapter that
comes with Dana, or one that meets the following specification: Input:
AC 120v 60Hz 9W Output: DC 7.5V 500 mA. A fully charged Dana
should run for over 25 hours.
Using the AC adapter
1. Connect the AC adapter to the Dana AC port.
2. Plug the AC adapter into any AC current outlet.

Dana first time set up

1. Press the on/off key to turn on Dana.
2. Follow the instructions on screen to calibrate the Dana screen and
set the current date and time.
Note: If Dana does not turn on, see "Frequently Asked Ques-
tions" on page 59 for troubleshooting suggestions.
Important: For users outside the United States, choose the same
language for Dana and Palm Desktop software. Choosing a
language that does not match the Palm Desktop software is
not recommended or supported, and may result in data loss.
If you need to reselect a language on Dana, you must per-
form a hard reset. See "Resetting Dana" on page 55 for
details.
Getting Started with Dana 11