Unpacking The Autoloader - HP StorageWorks Ultrium 230 User's And Service Manual

Unpacking the autoloader

Before you begin, clear a work surface to unpack the autoloader. Select an open 2U computer
rack location or choose a desktop location near the host server.
CAUTION: If the temperature in the room where the autoloader will be installed varies by 30
degrees F (15 degrees C) from the room where the autoloader was stored, allow the autoloader to
acclimate to the surrounding environment for at least 12 hours before opening the shipping
container.
Unpacking the autoloader:
1. Before opening and removing the autoloader from the shipping container, inspect the container
for shipping damage. If you notice any damage, report it to the shipping company
immediately.
Open the shipping container; remove and set aside the accessory package.
2.
CAUTION: Do not set the autoloader on either end or sides.
3. Lift the autoloader and padding out of the container and place it on the work surface, top
facing up.
4. Carefully remove the shipping materials from the left and right sides of the autoloader. Remove
the bag from the autoloader. Save the packing materials in case you need to move or ship the
autoloader in the future (see
Figure 3 Removing the autoloader from the shipping container
Figure 3).
1/8 Tape Autoloader User and Service Guide 15