Output Level Adjustment; Vbs Output Level Adjustment; Test Saw Level Adjustment - Sony HXC-FB75H Service Manual

6-5.

Output Level Adjustment

6-5-1.

VBS Output Level Adjustment

Equipment: Waveform monitor or oscilloscope
Test point: TEST OUT connector
Preparations
• Camera setting
MENU: MAINTENANCE
PAGE: OTHERS
ITEM: CAM BARS → ON
Procedure
1. Set as follows by camera setup menu.
MENU: MAINTENANCE
PAGE: TEST OUT
ITEM: OUTPUT → VBS
2. Adjust this using the waveform monitor so that 100% White of color-bar becomes the following level.
• Adjustment item: [GAIN]
• Specification:
- NTSC: 714 mV (100 IRE)
- PAL: 700 mV
Setting after Adjustment
• Camera setting
MENU: MAINTENANCE
PAGE: OTHERS
ITEM: CAM BARS → OFF
6-5-2.

TEST SAW Level Adjustment

Note
After the prism block assembly is replaced, adjust the TEST SAW level.
Equipment: Waveform monitor (R, G, B)
Test point: SDI OUT connector
HXC-FB75H/HXC-FB75KC
6-28