Advertisement
Assembly
continued.
Step 12
Insert studs into screen cover.
Step 13
Load head assembly by inserting hose into post.
Insert head assembly into post.
Control knob should be above
decal on post.
3 Req'd Brass Reflector Studs
Attach head assembly to post,
and loosely install three screws.
Tighten screws securely.
3 Required
Small Screw
Step 14
Remove protective film from all reflector pieces prior to assembly.
Assemble Reflector Assembly
9 Req'd
3 Req'd
Acorn Nut
Flat Head Screw
1
Edge Pin
Install edge pins into the lower
lip of the reflector panel.
3
Install the Flat Head Screw into
the hole from the bottom of the first
two reflector panels.
After repeating the above steps
to assemble the third reflector
panel, set the top cap in place and
secure with washers and acorn
nuts. Make sure all nuts are snug,
but DO NOT OVERTIGHTEN.
Step 15
3 Req'd
3 Req'd
Acorn Nut
Washers
Support Heater.
Locate assembled reflector
on 3 studs (ref. Step 12).
Install washers on studs &
securely tighten acorn nuts but
do not overtighten! Use a
7/16" nut driver or open-end
wrench.
3 Req'd
9 Req'd
Washers
Edge Pins
2
Upper Stud
Place the other end of the Edge
Pin into a second panel of the
reflector. Place upper hole in sec-
ond piece over upper stud.
4
Loosely install the Flat Head
Screw in place with a washer and
Acorn Nut.
5
7
Advertisement
