Slider Section - Makita MAKSTAR BJR141 Series Technical Information

R
epair

[3] -2. Slider Section

DISASSEMBLING
1) Remove Shoe. (See Fig. 2 in page 3.)
2) Remove Blade clamp section. (See [3] -1. Blade Clamp Section in pages 3 and 4.)
3) Remove Insulation cover;
If replacing with new one, cut away using cutter knife.
If reusing removed Insulation cover, remove as illustrated in Fig. 13.
Fig. 13
Insulation cover has two raised
portions on its inside surface to
prevent from falling off from
the machine.
Insulation cover,
viewed from rear
raised portion (B)
raised portion (A)
4) Separate Gear housing cover complete from Gear housing
by unscrewing four M5x18 Pan head screws. (Fig. 14)
5) Remove two Plates that fix Plane bearing 14 by unscrewing
four M5x16 Pan head screws.
Remove Plane bearing 14 on the Motor housing side. (Fig. 15)
6) Move Slider towards the Motor housing side.
Slider can now be removed together with Plane bearing 14 on
the blade side by pulling in the direction of the gray arrow.
(Fig. 16)
Fig. 15
[blade side]
Slider
Gear housing
cover complete
Turn Insulation cover inside out
by hand until the raised portion (A)
is reached.
Insulation cover
Pan head screw M5x16 (4pcs)
Plate (2pcs)
Plane bearing 14
[Motor housing side]
Pull Insulation cover in the direction
of the arrow bit by bit while levering
off from Gear housing section using
two slotted screwdrivers.
Fig. 14
Pan head screw M5x18 (4pcs)
Slider section
Gear housing
cover complete
Gear housing
Fig. 16
Plane bearing 14,
on the blade side
P 6 /10
Gear housing section
Slider