Safety Information; Meaning Of The Safety Information - Parkside PSTKA 12 B3 Original Instructions Manual

GB
Bevel cutting
...................−45°; −22.5°; 0°; 15°; 30°; 45°
Sound pressure level (L
........................................ 77.2 dB(A); K
Sound power level (L
WA
– Measured ................. 88.2 dB(A); K
Vibration (a )
h
– Wood .................... 12.27 m/s²; K=1.5 m/s²
– Aluminium .............. 14.67 m/s²; K=1.5 m/s²
Levels of noise and vibration were determined
according to the standards and regulations in
the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been meas-
ured according to a standardised test method
and can be used to compare one power tool
with another. The specified total vibration value
and the stated specified noise emission value
can also be used for a provisional assessment
of the load.
WARNING! The vibration and noise emis-
sions may deviate from the specified values
during actual use of the power tool, depend-
ing on how the power tool is being used. Try to
Charging time PAPK 12 A1
(min.)
PLGK 12 A1
PLGK 12 A2
PLGK 12 B2
PDSLG 12 A1

Safety information

This section deals with the basic safety instruc-
tions for using the device.
WARNING! Injury and property dam-
age due to improper handling of battery. Ob-
serve the safety information and notes on char-
ging and proper use as shown in the instruction
manual for your battery and charger from the
series X 12 V TEAM. A detailed description
of the charging process and further information
can be found in these separate operating in-
structions.
22
)
pA
=5 dB
pA
)
=5 dB
WA
PAPK 12 A3 PAPK 12 A2
60
60
30
60
keep the exposure to vibrations as low as pos-
sible. An example of a measure to reduce vi-
bration exposure is limiting the working hours.
All parts of the operating cycle have to be con-
sidered while doing so (for example, times
when the power tool is switched off and times
when it is switched on but running without any
load).
Charging time
The device is part of the X 12 V TEAM
series and can be operated with batteries of
the X 12 V TEAM series. Batteries of the
X 12 V TEAM series may only be charged
using chargers of the X 12 V TEAM series.
We recommend that you operate this ap-
pliance with the following batteries only:
PAPK 12 A1, PAPK 12 A2, PAPK 12 B1
We recommend charging these batteries
with the following chargers: PLGK 12 A1,
PLGK 12 A2
Rechargeable battery and charger technical
data: See separate manual.
An up-to-date list of battery compatibility can
be found at: www.lidl.de/akku
PAPK 12 B1
PAPK 12 B2
PAPK 12 B3
60 120
60 120
45 60
45 60
Meaning of the safety
information
DANGER! If you do not observe this
safety instruction, an accident will occur. The
result of which is severe bodily injury or death.
WARNING! If you do not observe this
safety instruction, an accident may occur. The
result of which is likely severe bodily injury or
death.
CAUTION! If you do not observe this
safety instruction, an accident will occur. The
result of which is likely minor or moderate bod-
ily injury.
PAPK 12 D1
150
150
80
80