VTech Toot-Toot Drivers 4-in-1 Raceway. Instruction Manual page 6

INSTRUCTIONS
Battery Removal And Installation
Stunt Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the Stunt Car. Use a
screwdriver to loosen the screw and then open the battery cover.
3. If used batteries are present, remove from the unit by pulling up
on one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended are
to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
5