Example #4: Assign Vlan3 As The Default Vlan; Graphical User Interface; Private Edge Vlans - NETGEAR ProSafe FSM7328S Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide

Example #4: Assign VLAN3 as the Default VLAN

This example shows how to assign VLAN 3 as the default VLAN for port 1/2/2.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/2/2
(Netgear Switch) (Interface 1/2/2)#vlan pvid 3
(Netgear Switch) (Interface 1/2/2)#exit
(Netgear Switch) (Config)#exit

Graphical User Interface

Use the following screens to perform the same configuration using the Graphical User Interface:
• Switching --> VLAN--> Configuration. To create the VLANs and specify port participation.
• Switching --> VLAN --> Port Configuration. To specify the handling of untagged frames on receipt,
and whether frames will be transmitted tagged or untagged.

Private Edge VLANs

Use the Private Edge VLAN feature to prevent ports on the switch from forwarding traffic to each
other even if they are on the same VLAN.
• Protected ports cannot forward traffic to other protected ports in the same group, even if they
have the same VLAN membership. Protected ports can forward traffic to unprotected ports in
their group.
• Unprotected ports can forward traffic to both protected and unprotected ports.
You can also configure groups of protected ports. Each group's configuration consists of a name
and a mask of ports. A port can belong to only one set of protected ports, but if a port is
unprotected in one group it can be protected in another group.
The group name is configurable by the network administrator.
Use the switchport protected command to designate a port as protected. Use the show
switchport protected command to display a listing of the protected ports.
3-4
v1.0, March 2006
Virtual LANs