Table of Contents
Advertisement
www.ti.com
9
CLI Version
The CLI tool provides a traditional command line version of the Radio Tool. This version is especially useful when performing large-scale
automated testings. The RadioToolCLI.exe application is in the RadioToolApplication directory. Use CMD or batch files to execute the commands.
Usage: RadioToolCLI -X [-P=port] [-B=baud] [-M] [-F] [-T|-R|-POW]
RadioToolCLI [-h|--help] [-i|--info]
Options:
Miscellaneous:
-h, --help
-i, --info
-v
Device Connection:
-X, --target=TARGET
-P, --port=VALUE
-B, --baud_rate=BAUD RATE
-M, --mac
-C, --new_mac=VALUE
-F, --firmware
Common for TX and RX:
-t, --duration=DURATION
-c, --channel=CHANNEL
-k, --enable_acks
TX (Transmission):
-T, --tx
-z, --tx_type=TX_TYPE
-w, --power=POWER
-f, --tone_offset=TONE_OFFSET
-m, --rate, --modulation=MODULATION
SWRU471A – February 2017 – Revised January 2019
Submit Documentation Feedback
Shows this message
Shows RadioToolCLI and radio tool library version and information.
increase debug message verbosity
The TARGET testing device. 0:CC3120 SPI, CC3135 SPI, 1:CC3120 UART,CC3135 UART 2:CC32X0
UART,CC3235 UART. REQUIRED. Range: [0, 2]. Default: 1
The port number of the target testing platform.
Required for UART connections. Range: [0, 255].
The BAUD RATE of the target COM port.
Required for UART connections. Range: [0, Int32.MaxValue].
Returns the MAC address
Set device MAC address WITHOUT colons. For example, if the MAC address is 01:23:45:67:89:
AB, enter 0123456789AB instead. Case insensitive.
Returns the firmware version and CC32xx application version (if applicable) in the
following order:
Chip ID, ROM version, Firmware version, Host Driver version, CC32xx App version, MAC
address.
RX/TX Testing DURATION in seconds for -T and -R options. Range: [1, 65535]. Default: 1
RX/TX Testing CHANNEL
for -T and -R options. Range: 2.4GHz[1, 13] 5GHz[36-169]. Default:
1
TX ACKs enabling(For Rx mode). Default: disabled.
TX testing for Continuous or Packetized.
TX Testing TX_TYPE. 1:Continuous, 2:Packetized, 3:CW. 'tone_offset' option can be used if
and only if CW is chosen. Range: [1, 3]. Default: 1.
TX POWER attenuation for Continuous and Packetized testing. 0 being the maximum power and
15 being the minimum power.Range: [0, 15]. Default: 0
TX TONE_OFFSET for CW testing only. A value of N means tone at offset N*312.5kHz.
Range: [-25, 25]. Default: 0
TX Testing rate (with the corresponding MODULATION). Range: [1, 20]. Default: 1 (1Mbps
DSSS).
1: 1 Mbps (DSSS)
2: 2 Mbps (DSSS)
Copyright © 2017–2019, Texas Instruments Incorporated
®
CC3x20, CC3x35 SimpleLink™ Wi-Fi
and Internet-on-a chip™ Solution Radio
CLI Version
15
Tool
Advertisement
Table of Contents
