Rules Menu Options; Setting Times And Scheduling Firewall Services - NETGEAR FVS328 Reference Manual

Rules Menu Options

Use the Options checkboxes to enable the following:
• Enable VPN Passthrough (IPSec, PPTP, L2TP)
If LAN users need to use VPN (Virtual Private Networking) software on their computer, and
connect to remote sites or servers, enable this checkbox. This will allow the VPN protocols
(IPSec, PPTP, L2TP) to be used. If this checkbox is not checked, these protocols are blocked.
• Drop fragmented IP packets
If checked, all fragmented IP packets will be dropped (discarded). Normally, this should NOT
be checked.
• Block TCP flood
If checked, when a TCP flood attack is detected, the port used will be closed, and no traffic
will be able to use that port.
• Block UDP flood
If checked, when a UDP flood attack is detected, all traffic from that IP address will be
blocked.
• Block non-standard packets
If checked, only known packet types will be accepted; other packets will be blocked. The
known packet types are TCP, UDP, ICMP, ESP, and GRE. Note that these are packet types, not
protocols.

Setting Times and Scheduling Firewall Services

The FVS328 Firewall uses the Network Time Protocol (NTP) to obtain the current time and date
from one of several Network Time Servers on the Internet. In order to localize the time for your
log entries, you must select your Time Zone from the list.
Protecting Your Network
Model FVS328 ProSafe VPN Firewall with Dial Back-up Reference Manual
May 2004, 202-10031-01
6-13