NETGEAR FR114P Installation Manual page 12

5 Connect and Configure Other
5
Computers (Optional)
Now that you have one computer set up to access the Internet through the firewall, you can
connect other computers so they can share the modem.
1. Connect a Category 5 Ethernet patch cable between another computer and one of the
remaining numbered Local ports on the firewall.
2. Check to make sure that the associated port number's Link light is lit. The light flashes
when data is being transferred over the connection.
Cable/DSL
PWR
Note: If the numbered Link light isn't lit, go to Troubleshooting on page 13.
3. Go back to Installation Step 3 (pages 8 and 9) and go through the sequence of steps
applicable for each computer.
4. Restart each computer.
5. Test each computer's connection by going to NETGEAR's Web site
(www.NETGEAR.com) from each computer.
Note: If you have more than 4 computers or devices to connect to this firewall, you
must connect them to a hub or switch (such as the NETGEAR 8-port Fast Ethernet
Switch) and then connect the hub or switch to the firewall. Connect the other hub or
switch to Port 4 of the FR114P and press the Uplink button. If Port 4's Link light is
not lit, change the Uplink button to the other position and check the Link light again.
By using hubs or switches, you may connect up to 253 computers to the firewall.
ProSafe Firewall/Print Server
ACT 100
TEST
ALERT LNK/ACT
PRINTER INTERNET
FR114P
MODEL
100
1 2 3 4
LNK/ACT
LOCAL
11