Lighting Instructions; Lighting The Burners - Coleman 9928 Series Use, Care & Assembly Manual

Lighting Instructions

WARNING
THE FOLLOWING RULES MUST ALWAYS BE
FOLLOWED IN THIS ORDER (Fig. 22):
1. OPEN THE GRILL LID! Any attempt to light the grill with
the lid down could cause an explosion.
2. Check that the burner control knobs are turned to "OFF".
3. DO NOT stand with your head or arms over the grill.
Fig. 22
3
1
Fig. 23
2
Right Burner
Knob
Igniter Switch
Left Burner
Knob

Lighting The Burners

1. Push and turn one of the burner control knobs counterclockwise
to the "HIGH" position. Wait 5 seconds (Fig. 23 and 24).
2. Push igniter button repeatedly until burner lights. You will hear a
snapping sound (Fig. 24).
3. If the burner does not light in 4 seconds, turn the control knob to
OFF and wait 5 minutes for the gas to clear before trying again.
4. The second burner can be ignited by turning it on after first
burner is lighted.
5. If the burner does not light on the second try, turn the control
knob to OFF and wait 5 minutes for the gas to clear, and then
try match-lighting the burner.
Fig. 24
Match Lighting
1. Strike and place the burning long wooden match (or use the
match extension or a butane lighter with extension) through the
spaces in the grill grates near the ports of the burner between the
heat tents (Fig. 25).
2. Push and turn the control knob counterclockwise to the
"HIGH" position.
3. The second burner can be ignited by turning it on after first
burner is lighted.
Use a LONG wooden match or a butane lighter with an
extension. Make sure all burner controls are off except for the
burner being lighted. If a long-reach match or lighter is not
accessible, use the match extension. Insert a match in the
holder end of the extension, strike and place the burning match
near the BURNER being operated.
Fig. 25
English-9
CAUTION