Table of Contents
Advertisement
IMPORTANT RELEASE NOTES
This manual contains a new kit with new hardware, it is important to read through the diagrams and understand it. The
Multi-Function module is divided into two modules doing all steering functions including Cruise control. It is easier to
install, and less time consume. All modules support extreme low power in sleep mode, system total should add maximum
of 1.5mA to the car, this including modules that should be powered from Ignition but powered from battery by mistake.
TO OUR VALUED CUSTOMER
It is our intention to provide our valued customers with the best documentation possible to ensure successful use of our
products. We will continue to improve our publications to better suit your needs. Our publications will be refined and
enhanced, as new volumes and updates introduced. If you have any questions or comments regarding this publication,
please contact us.
CUSTOMER CARE CENTER
For additional application assistance, we urge you to consult with our experienced staff in our Customer Care Center. Our
Technical and Engineering staff has extensive test, research and development capabilities, and have assisted many
customers in solving unique design and application problems with standard or customized products.
R&D Contact Address
R.A.SH Tronics Ltd
rashtronix@gmail.com
ABSTRACT
This guide explains how to install the modules in the vehicle.
v The information provided in the wiring diagrams is vehicle specific. It should be applied only to the vehicle
indicated. Depending on the system you are installing, you may not install every module/harness.
v Read modules placement first, it is very important to understand were to connect and fit the CAN-Bus based
components to avoid future problems.
v This manual becomes an integral part of the vehicle the system-installed in. You should therefore always keep
it in the vehicle and pass on to the new owner, to safely use the systems.
v R.A.SH Tronics Ltd reserve the right to make changes in product specifications at any time and without prior
notice. The information in this manual, believed to be accurate and reliable. However, R.A.SH Tronics Ltd assume
no responsibility for its use.
USEFUL HINTS
v The electronic control board is an electrostatic sensitive device. Connect to a proper ground.
v Use care when making electrical connections. Disconnect battery power prior to servicing.
v When installing, check for any obstructions such as Gas tank, Gas lines, Wires, etc. before drilling or routing
power cable.
v For continued protection against fire hazard, replace only with the same type and rating of fuse.
v Only allow R.A.SH Tronics factory trained technicians to install or service your system. If wear is observed
on any part in the system, contact us.
We welcome your feedback.
US Support Contact Address
Clock Mobility
6700 Clay Ave. SW
Grand Rapids, MI 49548
(616) 698-9400
technicians@clockmobility.com
2
Advertisement
Table of Contents
